Bonsai tree: Transplanting Tips: An Uncommon Technique

Thursday, April 8, 2010

Bonsai tree: Transplanting Tips: An Uncommon Technique

Mystified? If you are not familiar with the technique shown here, you just might be.
The technique shown here is particularly good if you want to replenish the soil while leaving some of the roots undisturbed. Doing this lessens stress and hastens recovery.
The technique is useful when you want move a tree from a larger to a smaller pot, or into a pot that has a different shape. It also works when you want to replenish some of the soil and then put the tree back into the same pot and is particularly useful for repotting forest plantings.

If the roots aren’t well enough established to hold the soil together when you take the tree out of the pot, then this technique won’t work. Ergo, this technique is particularly good when dealing with potbound trees.
Before. A well developed Satsuki azalea in the wrong pot
Cutting corners. Because you are going from a rectangular pot to a round pot, you start by cutting off the corners.
Removing the bottom roots. In almost all cases, you want to remove the lower roots. This encourages roots to spread out rather than grow down; because the tree mirrors the roots, it encourage the above ground growth to spread, which is want you usually want with bonsai. Another reason to remove the bottom roots is to make more space to replenish the soil.
Little pieces of pie. Next, cut out little pie shaped pieces. Be careful to avoid damaging key roots that are supporting the nebari.
Removing the wedges.

Protecting the nebari. Notice how the wedges aren’t too close to the nebari. It takes a long time to develop an impressive nebari, so great care is taken to protect it.
A couple steps later. After wire has been threaded though the drainage holes and fresh soil has been put into the bottom of the pot, the tree is placed into position and soil is used to fill in the rest of the empty spaces, including the where the little wedges were removed. The soil used her is Kanuma. It’s from Japan and is favored by the Japanese for azaleas.
Tapping the pot. You can use your fist or a rubber mallet to lightly tap the pot to help the soil settle in. Notice the wire that will be used to secure the tree into the pot. Some westerners don’t bother with this, though all Japanese bonsai artists do bother. Wind and other factors can cause a tree to become loose in the pot. This can damage roots and impede growth.
After: Doubly improved. The tree looks much better in this pot and healthy new roots can grow into the fresh soil. All you need now is water and some good fertilizer.

Source: Bonsai Bark


Post a Comment